Worm Gear Speed Reducer

Worm Gear Speed Reducer WPKS

1. The base-plate must be plane and stoutness and the base-plate must be screwed down and shock proof.

2. The connecting shaft of prime mover, reducer and operation device must be coaxial installation.

3. The diameter tolerance zone of input and output shaft is H6, the holes of fittings such as couplings, sprocket wheel and so on.its must properly mate the shaft, which prevents bearing from breakage because of over-loose mate.

4. Drivers such as sprocket wheel and gear must be fitted close to bearings in order to reduce bending stress of hanging shaft.

Notice Of Usage

1. Check carefully whether the reducer model , distance, ratio, input connecting method , output shaft structure, input and output shaft direction and revolving direction accord with required before using,

2. Please fill proper category and brand lubricant according to the requirement of selecting lubricant oil in the product manual. And then screw on the vent-plug, unlock the small cone-plug of vent-plug. Only after doing these, reducer is already for starting up running. The proper brand and adequate lubricant oil is required, replace oil in time conforming to the request of product manual is also necessary, especially after using first 100hours, it is required refilling new oil.

3. When abnormal circumstances occur, please check and stop reducer per solutions and reasons for faults of reducer(allowable highest oil temperature is 95 under this temperature limit, if oil temperature no more goes up, please let reducer continue running).